You should just be able to cut and put new wires on it. Where did it break? If wires are sticking out from the end cap you can just splice them back. Could you post a pic of where it broke? Depending on the cap it should be a piece of cake.
was it the end cap or the tomb stone? the tombstone is where the prongs slide in? You should be able to get a new tombstone from Home depot or lowes. Ace normally does not have them. I would be happy to give you a hand with them if needed.
220g , large elite aquatics sump. 3 Radion Pro Gen 3 lights 3 Mp 40's
Thanks for the help. Aquatic dreams said they could easily replace it for me so I was just going to run it down to them tomorrow. If they can't do it I'll for sure take you up on your offer Iskurys.
Indefinite hiatus from sw aquariums.
Once I have my glorious return I'll set back up the following. 50 Gallon rimless cube. 180 Gallons mixed reef paradise
FYI pulling out old wires and striping new wires u can push them into the slot on the tombstone . they are self locking and can be removed by pushing on the end , its a gold looking tab u push and it releases the old wire . if u need further help i can post a pic on monday when im at work , good luck :)
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum