Calling anyone who knows power!!!
I hope this diagram shows up ok.
I have a workhorse dual 96watt ballast that went out and I replaced it with a different brand. the workhorse had 5 output wires (4 hot and 1 ground). The lights are wired with the ground in a T from the ballast.
The new ballast has 8 wires (4 hot and 4 ground).
I would prefer to not re wire my lights. Here is my question. Can I connect the 4 hots from the new ballast to the original 2x2 hot wires and connect all four grounds to the original 1 ground wire without blowing anything up?
Thanks for your help!!!
Jeff